Westside Power Outage

9 Comments
Reads 1774

By an edhat reader

We had a notice from SoCal Edison about our power near Chino/Islay being out for 30 mins at 9am today. It's now 1:30pm and the power is still out. Is anyone else experiencing this?

I wish their notice would have stated it would take over 5 hrs instead of 30mins so we could all prepare.

Login to add Comments

9 Comments

Show Comments
a-1623882722 Jun 16, 2021 03:32 PM
Westside Power Outage

Over near West Micheltorena the planned power outages were brief, less than twenty minutes each (one about 9:10 AM and one just after 2:00PM. More expected on June 22 and 23.

SoCalMommy Jun 16, 2021 04:12 PM
Westside Power Outage

Modoc at Portesuello, a 15 minute outage this morning from 9:10-9:25ish, and an outage at 2pm that lasted less than 10 minutes.

patrick Jun 16, 2021 04:27 PM
Westside Power Outage

We received advance warning from SCE. It is related to pole replacements. Today had two 30 minute planned outages, but tomorrow the power is supposed to be off from 8AM to 4PM when they do the major work. We live on Gillespie near Eucalyptus.

patrick Jun 16, 2021 05:38 PM
Westside Power Outage

We just received another advance warning of a power outage from 8PM June 22 to 4AM June 23. (Again, we are on Gillespie near Eucalyptus.) I am not sure how big of an area will be affected.

tagdes Jun 16, 2021 06:00 PM
Westside Power Outage

Ours is for off of East Alamar, same time and date.

macpuzl Jun 16, 2021 04:35 PM
Westside Power Outage

We went through several power shutdowns for 8-10 hours at a time for pole replacements and more robust wires. Now, when the wind is howling, we no longer get the power drops and surges we used to see.

SBSand Jun 16, 2021 07:41 PM
Westside Power Outage

I've noticed that too in my part of town. It's not perfect but improved!

d8vanilla Jun 16, 2021 08:13 PM
Westside Power Outage

I got home around 8pm, and my power is ON, and it doesn't look it was ever off.... My clock radio still has the correct time, and isn't flashing....

Please Login or Register to comment on this.